Table of Contents
Advertisement
Troubleshooting
Getting Printer Information over the Network
Note
The optional Network Interface Board is required to acquire printer informa-
tion over the network.
Printer current status
You can check the printer's current status using the following method.
telnet
Use the status command.
4
Reference
For more information about the printer configuration with this method,
see the "Operating Instructions" for the optional Network Interface Board
included as a PDF file on the CD-ROM.
Message
Call Service
Charger : Not Set Correctly The charger is not set cor-
Energy Save Mode
Error Power Off/On
Front Cover Open
Fusing Oil is Low
Fusing Oil is Empty
Fusing Unit: Not Set Cor-
rectly
Left Cover Open
Loading Toner
44
Description
There is a malfunction in
the printer.
rectly.
The printer is in Energy
Saver mode.
There is malfunction in the
printer.
The front cover is open.
Fuser oil is low. You can
print about 200 pages more
after this message appears.
The fuser oil bottle is emp-
ty.
The fusing unit is not in-
stalled in the printer.
The left cover is open.
The toner cartridge is being
prepared for replacement.
Comments
Turn the printer off and on.
Set the charger correctly.
P.80 "Replacing the Charger"
Wait for a while.
Turn the printer off and on.
Close the front cover.
"Setup Guide" that comes
with the printer
Replace the fuser oil bottle.
P.76 "Replacing the Fuser
Oil Bottle and Ozone Filter"
Replace the fuser oil bottle.
P.76 "Replacing the Fuser
Oil Bottle and Ozone Filter"
Contact your sales or ser-
vice representative.
Close the left cover.
"Setup Guide" that comes
with the printer
Wait for a while.
the
the
Advertisement
Table of Contents
