Table of Contents
Advertisement
Troubleshooting
Message
Paper Tray : Not Set Cor-
rectly
PCU : Not Set Correctly
Ready
4
Rear Cover Open
Time to Change Charger
Time to Change Fusing
Unit
Time to Change PCU
Toner : Not Set Correctly
Warming Up
Waste Toner is Full
Waste Toner is Nearly Full The waste toner bottle is
WasteToner : Not Set Cor-
rectly
xxx Toner is Empty
*1
This message appears when you use the duplex printer.
46
Description
The paper tray is not in-
stalled correctly.
The tray on the paper feed-
ing path is not set correctly
when the printer receives
the print job.
The photoconductor unit is
not installed in the printer.
Printer works properly.
The rear cover is open.
*1
It is time to replace the
charger.
It is time to replace the fus-
ing unit.
It is time to replace the pho-
toconductor unit.
The toner cartridge is not
installed correctly.
The printer is preparing for
printing.
The waste toner bottle is
full.
nearly full.
The waste toner bottle is
not installed correctly.
The indicated toner is low
or has run out.
Comments
Install the paper tray cor-
rectly.
Install the paper tray cor-
rectly. The printer will re-
start printing
automatically.
Install the photoconductor
unit correctly.
P.74 "Re-
placing the Photoconductor
Unit"
—
Close the rear cover.
"Setup Guide" that comes
with the printer
Replace the charger.
P.80 "Replacing the Charger"
Contact your sales or ser-
vice representative.
If printed side gets dirty,
replace the photoconduc-
tor unit.
P.74 "Replacing
the Photoconductor Unit"
Install the cartridge cor-
rectly.
P.71 "Replacing
Toner Cartridge"
Wait until the printer is
warmed up.
Replace the waste toner
bottle.
P.78 "Replacing
the Waste Toner Bottle"
Replace the waste toner
bottle.
P.78 "Replacing
the Waste Toner Bottle"
Install the waste toner bot-
tle correctly.
P.78 "Re-
placing the Waste Toner
Bottle"
Replace the indicated toner
cartridge.
P.71 "Replacing Toner
Cartridge"
the
Advertisement
Table of Contents
