Setting Menu - promethean ActivPanel AP6-65-4K User Manual

Setting menu

Item
Language Setting
Menu Time
HDMI Settings
Source Scan
Movie Mode
Backlight Setting
Boot Setting
Temperature Setting
No signal shutdown
HDMI output format
Network Info
Restore To Default
Settings
Standby Time
Shutdown Time
Version
TC FW Version
TC Serial No.
HDMI Settings menu
Item Function
Color Range Set the displayed color range
EDID Version Extended Display Identification Data. This is the protocol that allows the PC or Mac know what
driver or device is attached as an extended monitor. The version of EDID is provided by the PC or Set
Top Box.
HDMI-CEC Consumer Electronics Control
79 ActivPanel System Install and User Guide
Function
Set the required language
Set how long the menus are displayed
Adjust settings related to the HDMI
Set if the panel scans for connected devices
Adjust backlight settings
Set how the panel should boot up
Set the unit of temperature to be displayed on the
menu
Set if the panel shuts down if no source signal is
found
Controls HDMI output quality.
View network information.
Restore the factory default settings
Set how long the panel is idle for before it enters
standby
Set how long the panel is idle for before it shuts down
Shows the current panel firmware version
Shows the touch controller version number
Shows the touch bezel serial number
Description
Opens a sub menu screen.
Choose the required language from the list.
5s, 10s, 15s, 20s, 30s, or Always
Opens a sub menu screen. (See separate table
below)
Manual/Automatic/Off
Off/On
Opens a sub menu screen. (See separate table
below)
Opens a sub menu screen. (See separate table
below)
Centigrade/Fahrenheit
Off/On
Default is 1920 x 1080
Displays the MAC address and network IP
Opens a dialog window OK/Cancel
2 min, 5 min, 10 min, 20 min, or 30 min
30 min, 60 min, 120 min, 180 min, 240 min, or Never
Description
Auto, 0~255,
16~235
Default (2.0),
EDID 1.4,
EDID 2.0
Off/On