Removing The Cover - MGE UPS Systems Galaxy 3000 Installation And User Manual

CAUTION
2.4

Removing the Cover

1. Remove the cover "3" secured by the screws "1".
2. Run the communications cables through the cable entry holes "4".
3. Connect the conductors to the input "6" and output "5" terminal blocks (see connection example in diagram
below).
Figure 2-2: Remove Cover Diagram.
1
2
5 6
3 4
2
1
B
A
6
2.4.1 Replacing the Cover
1. Put the cover back in place and secure it with the screws "1".
2. Tighten the screws "7" to block the cables.
3. Indicate the locations of the power sources on the labels.
4. Insert the card in its slot.
5. Secure the card with two screws "1", "2".
86-172010-00 C05
Isolate and lock-out all power sources for this card before
making connections. Never connect ELSV (extra low safety
voltage) and non-ELSV circuits to the different outputs of the
same card.
2
3
4
1
B
A
6
5
7
2
7
Installation
Remove Cover
5
6
5
4
3
2
4
Replace Cover
1
2
Installation and User Manual
3
2 — 5