Ricoh 3030 Operating Instructions Manual page 91

When using the exposure glass
A Press the {Start} key.
When scanning is finished, the
time remaining to place addi-
tional originals is displayed.
Note
❒ The selected destination ap-
pears while scanning the
originals.
B When there are additional orig-
inals, place them within the
specified time, and then press
the {Start} key.
Repeat this step until all origi-
nals are scanned.
Note
❒ If you change settings while
the machine is waiting for
additional originals, the
countdown stops. Press the
{Start} key to resume the
countdown and scanning.
When using the ADF
A Select [SADF] in [Original Feed
Type].
Note
❒ If [SADF] does not appear, se-
lect [SADF] in [Switch to Batch]
of [Scanner Features]. See.
p.106 "Switch to Batch".
Scanning Originals in Several Times
B Press the {Start} key.
When scanning is finished, the
time remaining to place addi-
tional originals is displayed.
Note
❒ The selected destination ap-
pears while scanning the
originals.
C When there are additional orig-
inals, place them within the
specified time.
The machine starts scanning au-
tomatically.
Note
❒ If you change settings while
the machine is waiting for
additional originals, the
countdown stops. Press the
{Start} key to resume the
countdown and scanning.
❒ You can also use the expo-
sure glass instead of the
ADF. In this case, you must
press the {Start} key to start
scanning.
D
When all originals are scanned
and the countdown is finished,
the machine starts storing or
sending automatically.
Note
❒ You can also press the {#} key
to start storing or sending.
7
83