Operating Instructions; Using The Control Panel; Menu Map; Configuring The Starting Address - Chauvet Intimidator SCAN LED 300 User Manual

4. O
PERATING

Using the Control Panel

Access control panel functions using the four buttons located directly underneath the LED display on the
included wired remote.
B
UTTON
<MODE
ESC>
<DOWN>
<UP>
<ENTER>
Use the control panel to select the operating mode, as well as the sub-features. For a detailed layout of the
control panel functions, please see the "menu map" section on the previous page.

Menu Map

Menu
DMX Mode
Standalone Mode
Pan Invert
Tilt Invert
Display Invert
DMX Personality
Reset
Load Default

Configuring the Starting Address

The Intimidator™ Scan LED 300 fixture uses up to 11 DMX channels. In this DMX configuration/personality,
the highest channel that the fixture may be set to in order to function properly is 502. Any address higher
than this will prevent access to all of the channels, while in this mode; however, if you desire to use one of
the other DMX channels configurations (personalities), please consider the total DMX channels when
selecting a DMX address.
The Intimidator™ Scan LED 300 fixture uses 8 or 11 DMX channels, depending on the selected DMX
configuration (personality).
Page 9 of 17
I
NSTRUCTIONS
F
UNCTION
Used to scroll through the current
operating mode, as well as back out of
the current menu option
Used to select decreasing advancement
in the value
Used to select increasing advancement
in the value
Used to select a value and store it to
memory
Programming Steps
d001
SLAu
NASL
NStS
NAFA
PAN
tit
diS
11CH
rESt
LoAd
d001~512 DMX starting address
NASL
SoN Standalone: Slave receive mode
SrUn Standalone: Slow
FASt Standalone: Sound-active
rPAN Pan invert
rtit Tilt invert
rdiS Invert the display
8CH 8-channel DMX personality
11CH 11-channel DMX personality
Reset all motors to correct any errors with
motors misaligning during operation
Revert all settings back to the factory
default
Intimidator Scan LED 300 User Manual (Rev. 3)
Description