Operating Instructions; Control Panel; Navigation Functions; Menu Map Description - Chauvet Sparklite LED User Manual

4. Operating Instructions

Control Panel

Navigation
Functions
Menu Map
Description
Programming
Procedure
12-Channel DMX
Mode
April 8, 2010
The SparkliteLED™ controller has a control panel to configure its functions. You can
access these functions by using the four panel buttons located directly under the
LCD Display. The table below explains the functions of those buttons.
Button Function
Used to access the menu
<MENU> or to return to a previous
menu option
<ENTER> Selects a menu option
Scrolls through menu
<UP> options in ascending
order
Scrolls through menu
<DOWN> options in descending
order
The Control Panel LCD Display has two lines. The upper line shows the menu items
the user selects from the menu map. While navigating the menu map, only the upper
row is active. When the user reaches a menu function that has an option to be
accepted or changed, the display will show it on its lower row.
·
To move to the right side of the menu map (next level), press <ENTER>. This will
serve to accept the current option and move forward.
·
To move up or down in the menu map, use <UP> and <DOWN>. This will show
the available options for the current menu item.
·
To move to the left side of the menu map (previous level), press <MENU>. This
will return the display to the previous option or exit the current option without
changing its value.
The menu map in page 17 shows the various programming levels and the functions
they contain. Use the control panel buttons, as shown above, to navigate it.
To start programming the SparkliteLED™ controller, the display must show MENU.
On power up, MENU shows on the display automatically. However, if someone has
already configured the SparkliteLED™ controller, its display may be showing the
current mode.
If MENU does not show on the display, press <MENU> repeatedly until MENU
appears.
This is the top of the menu map. At this point, <ENTER>, <UP> and <DOWN> will
not work.
·
With MENU showing on the display, press <MENU> once.
The display will show 12CH DMX Mode.
·
Press <ENTER> to select this option.
The lower row of the display will show [SET] select.
·
Press <ENTER> again to enable the 12-Channel DMX mode.
The display will show 12CH DMX512, which means that the 12-Channel DMX
mode is now active.
If using multiple SparkliteLED™ controllers in the 12CH DMX Mode, remember
to connect them using the proprietary serial link, not the standard DMX link.
13
Operating Instructions
SparkliteLED™ User Manual - Rev. 02c