Setup; Fuse Replacement; Mounting; Orientation - Chauvet LX5 User Manual

3. S
ETUP

Fuse Replacement

With a flat-head screwdriver wedge the fuse
holder out of its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.

Mounting

Orientation

This product may be mounted in any position provided there is adequate room for ventilation.

Rigging

It is important never to obstruct the fan or vents pathway. Mount the
product using, a suitable "C" or "O" type clamp. Adjust the angle of
the product by loosening both knobs and tilting the product. After finding
the desired position, retighten both knobs.
·
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
·
Safety cables must always be used.
·
Never mount in places where the product will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
4. O
PERATING
The LX5 can operate in Sound-Active or Auto mode, which is determined by the position of the switch
located on the rear of the unit. The mode of the unit refers to the reaction of the LEDs only as there
are no moving parts in the unit. To switch between the two modes, place the switch in either the "I" or
"O" position.
In the "I" position, the product operates in Sound-Active mode, the sensitivity of which can be
adjusted by the knob also located on the rear of the unit. To increase the sensitivity of the unit rotate
the knob clockwise.
In Auto Mode, the light will progress through a pre-programmed routine, whether sound is present or
not.
LX5™ User Manual
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
I
NSTRUCTIONS
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
5
Hanging Clamp
Note!
Clamp is sold separately.
Rev. 3