Troubleshooting
Messages/Second messages
Replace
Waste Toner
Reset PCU
Correctly
Reset Fusing
Unit Correctly
Reset Paper
Bypass Tray
Reset Toner
5
/Yellow/Magenta/Cy-
an/Black
Reset Tray #
Correctly
Reset
Duplex Unit
Replace
Transfer Belt
SC XXX-X
Power Off On
Toner is Almost
Empty: Black
Toner is Almost
Empty: Cyan
58
Description
It is time to replace the waste
toner bottle.
The black or color PCU is not
set correctly or is not set.
The fusing unit is not set cor-
rectly or is not set.
There is paper left in the By-
pass Tray.
The indicated toner car-
tridge(s) is/are not set correct-
ly
The indicated tray is not set or
is not set correctly.
#: tray number
The duplex unit is not set cor-
rectly or is not set.
It is time to replace the trans-
fer belt.
The Service Code or SC
number indicates the prob-
lem.
The black toner is almost emp-
ty.
The cyan toner is almost emp-
ty.
Solution
Replace the waste toner bottle
with a new waste toner bottle.
See p.29 "Replacing Consum-
ables and Maintenance Kit".
Set the black or color PCU cor-
rectly.
See p.29 "Replacing Consum-
ables and Maintenance Kit".
Set the fusing unit correctly.
See p.29 "Replacing Consum-
ables and Maintenance Kit".
Remove paper from the By-
pass Tray, and then reset the
paper.
Set the indicated toner car-
tridge correctly.
See p.29 "Replacing Consum-
ables and Maintenance Kit".
Set the tray correctly.
Or press the { { { { Form Feed} } } } key
several times until the tray
with the desired paper setting
appears on the panel display.
Or press the { { { { Job Reset} } } } key to
cancel the print job.
Remove and reinstall the du-
plex unit. If the message ap-
pears again, contact your sales
or service representative. See
the Option Setup Guide.
Replace the transfer belt with
a new transfer belt.
See p.29 "Replacing Consum-
ables and Maintenance Kit".
Turn the power switch off and
on. If the message appears
again, contact your sales or
service representative.
Prepare a new black toner car-
tridge.
Prepare a new cyan toner car-
tridge.