Ricoh Aficio CL3000 Maintenance Manual page 60

Troubleshooting
Messages/Second messages
Hardware Problem
Option RAM
Hardware Problem
Parallel I/F
Hardware Problem
USB
5
Invalid Password
Try Again
Load Correct
Size Paper
/Press #
To Continue
Load Paper
/Paper Size:
Paper Type
56
Description
There is a problem with the
optional Memory Unit.
There is a problem with the
parallel interface.
There is a problem related to
the Universal Serial Bus Con-
nection and Hardware.
The entered password is not
correct.
The paper size set in the indi-
cated tray differs from the set-
ting made.
The paper size set in the indi-
cated tray differs from the set-
ting made.
Solution
Remove and reinstall the op-
tional Memory Unit. If the
message appears again, con-
tact your sales or service rep-
resentative.
See the Option Setup Guide.
If you use the parallel inter-
face, replace the interface ca-
ble that caused the error. If the
message appears again, con-
tact your sales or service rep-
resentative.
Remove and reinstall the USB
board. If the message appears
again, contact your sales or
service representative.
Enter the correct password.
Load paper of the selected size
in the tray, and then press the
{ { { { Enter #} } } } key to resume print-
ing. If you want to ignore the
message and continue print-
ing, press the { { { { Enter #} } } } key.
Load paper of the selected size
in the tray, and then change
the paper size setting with the
control panel.
Or press the { { { { Form Feed} } } } key
several times until the tray
with the desired paper type
and paper size appears on the
panel display.
Or press the { { { { Job Reset} } } } key to
cancel the print job.
Load paper of the selected
type in the tray, and then
change the paper size setting
with the control panel.
Or press the { { { { Form Feed} } } } key
several times until the tray
with the desired paper type
and paper size appears on the
panel display.
Or press the { { { { Job Reset} } } } key to
cancel the print job.