Troubleshooting
Messages/Second messages
Call Service: EC
Power Off On
Cannot check
Signal in Ad hoc
Change Setting
Tray #
/Paper Size:
Paper Type:
5
Close Front and/
or Right Cover
Close Upper Left
Cover
Color Regist
Error
Error: Tray #
Form Feed
/Reset The Job
Then Power OffOn
Hardware Problem
Black PCU
54
Description
A communication error sent
from the engine to the control-
ler.
The signal strength for the
wireless LAN cannot be
checked because "Ad hoc" is
selected in "Comm. Mode" for
"IEEE 802.11b" in the Host In-
terface menu.
The paper size or paper type
set in the indicated tray differs
from the setting made.
#: tray number
The front or right cover of the
printer is open.
The upper left cover of the
printer is open.
Color registration has failed.
There is a problem with the in-
dicated tray.
#: tray number or Bypass Tray
An error has occurred in the
black PCU (Photo Conductor
Unit).
Solution
Turn the power switch off and
on. If the message appears
again, contact your sales or
service representative.
Change the transmission
mode to [Infrastructure] in the
Host Interface menu.
Load paper of the selected size
and type in the tray, and then
change the paper setting with
the control panel.
Or press the { { { { Form Feed} } } } key
several times until the tray
with the desired paper type
and paper size appears on the
panel display.
Or press the { { { { Job Reset} } } } key to
cancel the print job.
Close the front or right cover
of the printer.
Close the upper left cover of
the printer.
Turn the power switch off and
on. If the message appears
again, contact your sales or
service representative.
Press the { { { { Form Feed} } } } key to
select another tray and make a
print, or turn the power
switch off and on. If the mes-
sage appears again, contact
your sales or service repre-
sentative.
Turn the power switch off and
on. If the message appears
again, contact your sales or
service representative.