Advertisement

Quick Links

SPECIFICATIONS
41.5 in
Wingspan:
[1055 mm]
2
Wing
297 in
2
Area:
[19.2 dm
]
28 – 31 oz
Weight:
[795 – 880 g]
WARRANTY
Hobbico guarantees this kit to be free from defects in both
material and workmanship at the date of purchase. This
warranty does not cover any component parts damaged by use
or modification. In no case shall Hobbico's liability exceed the
original cost of the purchased kit. Further, Hobbico reserves
the right to change or modify this warranty without notice.
In that Hobbico has no control over the final assembly or
material used for final assembly, no liability shall be assumed nor
accepted for any damage resulting from the use by the user of
the final user-assembled product. By the act of using the
user-assembled product, the user accepts all resulting liability.
If the buyer is not prepared to accept the liability associated
with the use of this product, the buyer is advised to return
READ THROUGH THIS MANUAL BEFORE STARTING CONSTRUCTION. IT CONTAINS IMPORTANT
INSTRUCTIONS AND WARNINGS CONCERNING THE ASSEMBLY AND USE OF THIS MODEL.
© 2015 Flyzone, a Hobbico company.
2
Wing
13.6 – 15 oz/ft
2
Loading:
[42 – 46 g/dm
]
34.5 in
Length:
[875 mm]
4 – 5-channel
Radio:
(required)
this kit immediately in new and unused condition to the
place of purchase.
To make a warranty claim send the defective part or item to
Hobby Services at the address below:
Include a letter stating your name, return shipping address, as
much contact information as possible (daytime telephone
number, fax number, e-mail address), a detailed description of
the problem and a photocopy of the purchase receipt. Upon
receipt of the package the problem will be evaluated as quickly
as possible.
INSTRUCTION MANUAL
Hobby Services
3002 N. Apollo Dr. Suite 1
Champaign IL 61822 USA
®
FLZA3024 Mnl

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the extra 300 sx and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Flyzone extra 300 sx

  • Page 1 READ THROUGH THIS MANUAL BEFORE STARTING CONSTRUCTION. IT CONTAINS IMPORTANT INSTRUCTIONS AND WARNINGS CONCERNING THE ASSEMBLY AND USE OF THIS MODEL. © 2015 Flyzone, a Hobbico company. FLZA3024 Mnl...
  • Page 2: Additional Items Required

    INTRODUCTION LiPo Charger Thank you for purchasing the Flyzone Extra 300SX. The The bare minimums to look for in a charger are LiPo Extra was originally intended as a 3D-capable platform, balancing and the ability to charge at a minimum rate of but because of its power-to-weight ratio and well- 1C.
  • Page 3 Fuselage Wing 10 x 4.5 propeller Foam fuselage Foam wing 1-3/4" spinner Foam canopy hatch w/pilot Aileron servos (2) Propeller adapter assembly Foam cowl Servo extensions Elevator joiner rod 30A ESC Y-harness Tail gear assembly Motor Aileron linkage (pushrods, screw-lock Elevator servo connectors, 90°...
  • Page 4 ❑ 2. Key in one stab half, then the other simultaneously fi tting the other end of the joiner tube into the other ❑ 5. Fit the tail gear wire into the tail gear assembly and elevator. Press both halves fi rmly together to make sure secure with the M3 set screw lightly wetted with thread they are centered in the fuselage and securely keyed all locker—a 1.5mm machined hex driver is preferred, but...
  • Page 5 The landing gear covers and wheel pants are magnetic and simply snap into place… ❑ 9. Mount your receiver in the fuselage with the included short, adhesive-back hook-and-loop strip—note that the high end of the receiver (that has the servo plugs sticking out) must be ahead of the instrument panel in the canopy hatch (marked by a line in the photo approximately 2-1/2”...
  • Page 6: Check/Set The Control Throws

    ❑ 3. Measure and set the control throws as specifi ed in the GET THE EXTRA 300SX READY TO FLY following table. Pilots not intending to perform 3D maneuvers may simply program their radio for low and high-rate throws. Check/Set the Control Throws Most 3D pilots will use the high-rate and 3D throws;...
  • Page 7: Check The C.g. (Center Of Gravity)

    Check the C.G. (Center of Gravity) Before checking the C.G. the propeller must be mounted… ❑ 1. Temporarily pop the cowl off the fuselage just to see how the motor and ESC are mounted and to make sure everything is connected properly. Reinstall the cowl. 64mm 2-1/2"...
  • Page 8: Set A Flight Timer

    And it can be stressful to your batteries, eventually decreasing performance in the long-run. Typical, average battery consumption with the Flyzone Additionally, or if you don’t have a charger with a digital Extra is approximately 200mAh/minute on 3S with the readout to fi nd out how much capacity you used during included PowerFlow 10 x 4.5 propeller (but can be as low...
  • Page 9: Battery Charging Precautions

    SAFETY PRECAUTIONS BATTERY CHARGING PRECAUTIONS • 1. Your Extra 300 SX should not be considered a toy, but Be careful to avoid overcharging the battery. Only use rather a sophisticated, working model that functions very a LiPo approved charger. Never use a NiCd/NiMH peak much like a full-size airplane.
  • Page 10 FORMULAS = B/A = D x 0.8 = E/C = (B/100)/(A/60) Flight Time Recharge Battery Target Capacity Recommended Average In-Flight (.10ths) Capacity mAh/minute Capacity to Use In Flight Flight Time Current...

Table of Contents