Access; Appletalk - Ricoh Network Guide Network Manual

access

Use the "access" command to view
and configure access control. You can
also specify two or more access ranges.
❖ ❖ ❖ ❖ View settings
msh> access
❖ ❖ ❖ ❖ Configuration
msh> access ✩ range "start-
address end-address"
• ✩ represents a target number
between 1 and 5. (Up to five ac-
cess ranges can be registered
and selected.)
Example: to specify accessible IP
addresses between 192.168.0.10
and 192.168.0.20:
msh> access
192.168.0.10 192.168.0.20
❖ ❖ ❖ ❖ Access control initialization
msh> access flush
• Use the "flush" command to re-
store the default settings so that
a l l a c c e s s r a n g e s b e c o m e
"0.0.0.0".
Note
❒ The access range restricts comput-
ers from use of the machine by IP
address. If you do not need to re-
strict printing, make the setting
"0.0.0.0".
❒ Valid ranges must be from lower
(start address) to higher (end ad-
dress).
❒ Up to five access ranges can be
specified. The entry is invalid if the
target number is omitted.
❒ You cannot access Web Image Mon-
itor from a restricted IP address.

appletalk

Use the "appletalk" command to view
and configure Appletalk parameters.
❖ ❖ ❖ ❖ View settings
❖ ❖ ❖ ❖ Changing PAP timeout configuration
1 range
Remote Maintenance by telnet
msh> appletalk
• [2] means "active" and [0]
means "inactive".
• The default is [2].
msh> appletalk ptimeout
value > 0
• Timeout value becomes effec-
tive.
msh> appletalk ptimeout
value = 0
• Timeout value becomes ineffec-
tive.
4
89