Show; Slp - Ricoh Network Guide Network Manual

• If Secured Sockets Layer (SSL,
an encryption protocol) func-
tion is not available for the
printer, you cannot use the
function by enabling it.
msh> set nrs {up | down}
msh> set rfu {up | down}
msh> set ipp {up | down}
msh> set http {up | down}
msh> set rendezvous {up | down}

show

Use the "show" command to display
network interface board configura-
tion settings.
❖ ❖ ❖ ❖ View settings
msh> show
• If "-p" is added, you can view
settings one by one.
Reference
For details about the information
displayed, see p.122 "Configuring
the Network Interface Board".
Remote Maintenance by telnet

slp

Use "slp" command to configure SLP
settings.
msh> slp ttl "ttl_val"
• You can search the NetWare server
using SLP in the PureIP environ-
ment of NetWare 5/5.1 and Net-
w a r e 6 / 6 . 5 . U s i n g t h e " s l p "
command, you can configure the
value of TTL which can be used by
SLP multicast packet.
• The default value of TTL is 1. A
search is executed only within a lo-
cal segment. If the router does not
support multicast, the settings are
not available even if the TTL value
is increased.
• The acceptable TTL value is be-
tween 1 and 255.
4
101