Programmable Key Functions - Icom IC-G88 Operating Manual

2

PROGRAMMABLE KEY FUNCTIONS

Programmable key functions (Continued)
VFO / User Set Mode
➥ Push to enter the VFO Set mode.
• The VFO Set mode is used to change settings for the
operation in the VFO mode.
➥ Hold down for 1 second to enter the User Set mode.
•
The User Set mode is used to set infrequently changed
values or status of functions without using a PC.
➥ In the User/VFO mode, push this key to select an
item, and then push [UP] or [DOWN] to change the
value or setting.
➥ In the User/VFO mode, hold down for 1 second to
exit the User/VFO Set mode.
Sp. Func 1/2
➥ Reserved for future function.
Announce
➥ Push to turn the Channel Announce function ON or OFF.
• In the Memory mode, the transceiver announces the
selected channel number.
Shift
➥ Push to switch the key functions, assigned into th
Normal mode and the Shift mode. The Shift mode en-
ables a programmable function key to have two functions.
1. Push to turn ON the Shift mode key functions.
• "SHIFT ON" is briefly displayed.
2. Push another key to activate its secondary func-
tion.
3. Push [Shift] again to turn OFF the function.
• "SHIFT OFF" is briefly displayed, and then the trans-
ceiver returns to the Normal mode.
VFO / Memory Mode
➥ Push to toggle between VFO and Memory modes.
➥ In the VFO mode, hold down for 1 second to write
the VFO data to the selected Memory channel.
➥ In the Memory mode, hold down for 1 second to
copy the Memory channel data to the VFO.
Duplex / Sub Audible Tone
➥ Push to select the Duplex mode from DUP–, DUP+
and OFF.
➥ Hold down for 1 second to select a Sub Audible
tone from Repeater tone, TSQL (Tone Squelch),
TSQL with Pocket Beep, DTCS-TX, DTCS, DTCS
with Pocket Beep and tone OFF.
e
4