Mdc 1200 System Operation; About The Mdc 1200 System; Receiving; D Receiving A Ptt Id - Icom IC-G88 Operating Manual

3
Section

About the MDC 1200 system

The MDC 1200 signaling system enhances your trans-
ceiver's capabilities. You can receive or transmit a PTT
ID. PTT ID is a calling station ID that is sent by pushing
or releasing [PTT].
An additional feature of the MDC 1200 system included
in Icom transceivers is called aliasing. Each transceiver
on the system has a unique ID number. Aliasing is a
substitute for this ID number and you can give an al-
phanumeric name for each station ID. In transmit, you
can use this alias to select a transceiver to call. In re-
ceive, the alias of the calling station is displayed in-
stead of the ID.

Receiving

D Receiving a PTT ID

1. When a PTT ID is received:
• Beeps sound.
• The calling station ID (or alias) is displayed.
< Calling station ID >
< Alias >
2. Hold down [PTT] and speak into the microphone.
3. Release [PTT] to receive a response.

MDC 1200 SYSTEM OPERATION

NOTE:
To use the MDC 1200 system, set the related set-
tings by using the CS-G88
(purchase separately).
The factory default is not set to allow the system op-
eration.

Transmitting

D Transmitting a PTT ID

Another person can view your station ID. If the same
alias is set at the receiving side, the alias is displayed
instead of the station ID.
1. Push [PTT] to make a call.
2. Beeps sound.
3. Your station ID will be transmitted when you push
[PTT] (at the beginning of transmission) or release it
(at the end of transmission), depending on the set-
ting in the CS-G88.
5
programming software