About The Connect Sensor I/O Interface; Connect Sensor Hardware Replacement; Digi Device Cloud And Digi Remote Manager; Safety Notices And Certifications - Digi Connect Sensor Wiring Manual

Hide thumbs Also See for Connect Sensor:

Table of Contents

About the Connect Sensor I/O interface

You can wire analog and digital inputs and outputs on the Connect Sensor general purpose I/O

interface.

Note

If you are using a Modbus-enabled external sensor device, you must wire the sensor device to a

serial output. Note that the Modbus protocol is available only with Connect Sensor+.

Make sure Connect Sensor has cellular connectivity before wiring sensors to the I/O interface. After

setting up Connect Sensor and wiring the I/O interface, use Remote Manager to remotely configure

I/O settings.

Connect Sensor hardware can be replaced with Connect Sensor+ hardware, which provides additional

external device monitoring features, such as using the HART® protocol and the Modbus protocol.

To serve our customers most effectively, Digi International Inc. consolidated its cloud services, Digi

Device Cloud and Digi Remote Manager®, under the Remote Manager name. This phased process does

not affect device functionality or the functionality of the web services and other features. However,

you will find instances of both Device Cloud and Digi Remote Manager in some documentation,

firmware, and user interfaces.

Digi products are designed to the highest standards of safety and international standards compliance

for the markets in which they are sold. However, cellular-based products contain radio devices that

require specific consideration. Make sure you read and understand all of the safety notices, warnings,

and cautions for this product. Digi International assumes no liability for failure to comply with the

safety precautions.

See the

Connect Sensor User Guide

When you update Connect Sensor with the CSENSE Continuous Monitoring firmware option, Connect

Sensor supports only one power output (A1 Pwr), which is on all the time. Multiple sensors can share

this supply, but all sensors must have the same input voltage and must be wired to A1 Pwr.

Digi Connect® Sensor I/O Wiring Guide

for details about safety and certification for Connect Sensor.

Table of Contents

Do you have a question about the Connect Sensor and is the answer not in the manual?