3. Depending on the method used, lower the forklift tines and move the forklift away or remove
the straps and move the rigging away.
4. Use the piano jacks to move the unit to the installation site.
•
At least 2 properly-trained and qualified personnel are required to move the unit with
piano jacks.
5. Once the unit is in the installation location, remove the unit from the piano jacks:
•
Lower the unit as far as the piano jacks will allow.
•
Undo all straps holding the unit to the piano jacks.
•
Use a pry bar or similar device to lift one end of the unit enough to remove one piano jack.
•
Repeat the previous step to remove the piano jack on the opposite end.
•
Remove the padding used to protect the unit from the piano jacks and strapping.
4.4 Placing the Unit on a Floor Stand
Liebert Floor Stand—Refer to the floor stand installation sheet shipped inside the floor stand package.
Lower the unit onto the floor stand.
NOTE: The floor stand for a Liebert PDX/PCW is not symmetrical. Its orientation to the unit is critical
for installation of the unit.
Vertiv | Liebert® PDX™ and PCW™ Installer/User Guide |
28