Konica Minolta bizhub 287 Service Manual page 17

Security Function Ver. 1.02 Mar. 2016
6. The default setting is "9272927292729272." Using the keyboard shown on the display,
enter "9272927292729272" in Current Password and touch [END].
7. From the keyboard shown on the display, enter a new password and touch [END].
NOTE
• Be sure to change the CE password.
• If the [Password Rules] is set to "ON," a password consisting of only the same
character or the same password as that set before the change cannot be set. In
this case, therefore, do not set a password having only the same character or a
same password as that set before the change.
Also, when the number of password characters is lower than the minimum number
of characters (initial value: 12 characters) as set out under [Set Minimum Pass-
word Length] in the [Password Rules], a new password will not be able to be set.
• The CE password should be set at a value which is not the initial value and which
is difficult to guess.
• The CE password can be set with up to 64 characters.
• Exiting from the Service Mode after the new CE password has been set validates
the setting of the new password.
• NEVER forget the CE password. When forgetting the CE password, call responsi-
ble person of KM.
7. Enhancing the security function
13
A7AHS1E006DA