Asr900-Rsp2 And Asr900-Rsp3 Led Information - Cisco ASR 902U Hardware Installation Manual

RSP LEDs
LED
Sync status (SYNC)
USB flash (MEM)
BITS

ASR900-RSP2 and ASR900-RSP3 LED Information

The PWR and STAT LEDs are available on the front panel. These LEDs provide power on the board (PWR)
and overall router health (STAT) status. During power up state, these LEDs provide booting status and report
errors.
The digital code signing functionality validates the integrity and authenticity of the ROMMON image
Note
before booting it.
Table 31: A900-RSP2 and A900-RSP3 LED
PWR LED State
Light Green
Cisco ASR 902 and ASR 902U Aggregation Services Router Hardware Installation Guide
132
Color/State
Off
Yellow
Flashing yellow
Green
Flashing green
Off
Amber
Green
STAT LED State Indication
Red Power is OK and the
field-programmable gate
array (FPGA) is nfigured
successfully, but FPGA
image validation failed.
Troubleshooting
Description (two LEDs for each
port)
Not enabled
Free run
Holdover
Locked to source
USB activity
Out of service/not configured
Fault or loop condition
In frame/working properly
Comment
Image validation failed.
System is in hung state.