Secure With Mounting Clips - Siemens SIMATIC IPC377E Operating Instructions Manual

Installing and connecting the device
3.2 Installing the device
IP65 degree of protection
Risk of electric shock
The specified degree of protection cannot be guaranteed if the device is not correctly
installed. Moisture or water could leak in and cause electric shock or destroy the plant.
The degree of protection IP65 is ensured for the front of the device under the following
conditions:
• The mounting cutout was prepared based on the correct dimensions; see chapter
• The device was secured with the supplied mounting clamps or with clamps which can
• The mounting seal is undamaged.
3.2.2

Secure with mounting clips

Positions of the mounting clips
To achieve the degree of protection for the HMI device, the positions for the mounting clips
shown below must be adhered to.
The positions of the mounting clips are marked by stamps on the cutouts. Fit the mounting
clips in all the stamped cutouts.
The following table shows the type, number, and position of the mounting clips needed for
the respective HMI devices.
HMI device
12" display
Requirement
● All packaging components and protective films should be removed from the device.
● To install the panel, you need the mounting clips from the accessories kit.
28
WARNING
"Preparing the mounting cutout (Page 25)".
be optionally ordered.
Type
Mounting clips
Quan-
tity
9
Position on the HMI device
Operating Instructions, 2017/05, A5E40965249-AA
SIMATIC IPC377E