Table of Contents
Advertisement
Anything special I should do before putting the mask on?
Before wearing your mask, wash your face to remove excess facial oils. This will
allow a better fit and prolong the life of the mask cushion.
Do not use moisturiser when wearing a mask.
My mouth feels dry during treatment—what can I do?
You may experience dryness of the nose, mouth, and/or throat during the course
of treatment, especially during winter. In many cases, a humidifier may resolve
this discomfort. Contact your clinician for advice.
My nose is irritated during treatment—what can I do?
You may experience sneezing and/or a runny or blocked nose during the first few
weeks of treatment. In many cases, nasal irritation can be resolved with a
humidifier. Consult your clinician or equipment supplier for advice.
Can I travel with the S8 Lightweight II?
Your S8 Lightweight II has an internal power supply that enables it to operate in
other countries. It will operate on power supplies of 100–240V and 50/60Hz. No
special adjustment is necessary, but you will require an approved power cord for
the region in which you are using the device.
Please consult the medical services department of your carrier if you intend to use
your S8 Lightweight II on an aircraft. The S8 Lightweight II complies with US FCC
Part 15, Class B requirements.
Note: Do not use your S8 Lightweight II while the aircraft is taking off or landing.
Can I use my S8 Lightweight II if mains (AC) power is not available?
A DC-12 converter is available to connect the S8 Lightweight II to a 12V or 24V
DC power source. Contact your clinician for details.
CAUTION
!
The device should not be connected to both AC and DC power sources
simultaneously.
Troubleshooting
If there is a problem, try the following suggestions. If the problem cannot be
solved, contact your equipment supplier or ResMed. Do not attempt to open the
device.
Problem/Possible Cause
No display
Power is not connected.
Displays error message:
MOTOR FAULT Call Service
DATA LOST Call Service
Component failure.
Ensure the power cable is connected and the power
switch (if available) is on.
Exxxx Call Service
or
UPLOAD LANGUAGES Call Service
Call service.
Solution
(where
defines an error) or
xxxx
or
Troubleshooting
11
Advertisement
Table of Contents
