9- Configure The Sl2100; Connecting Pcpro To The Sl2100 - NEC SL2100 Quick Install Manual

Analogue trunks.
Hide thumbs Also See for SL2100:
Table of Contents

Advertisement

Configure the SL2100

9- Configure the SL2100

This Quick Install guide will cover the most frequently used configuration options. For advanced configuration
please refer to the SL2100 Features and Specifications manual.
You must have SL2100 PCPro installed to your laptop/PC, this can be downloaded from BusinessNet, refer to
the Quick Install Guide – SL2100 PCpro.
The SL2100 can also be configured via an SL2100 System phone or via a WebPro interface, these are not
included within this guide.
Before you configure your system it is important that you:
Have a diagram of your exchange lines and telephones.
Plan your requirements before you start.
While you configure your system it is advised that you:
Make a record of your configuration as you make each change.
Make small changes, upload to the SL2100 and test the changes. Avoid making all your changes at
once as this can make testing more difficult.
With the default/factory settings:
Each telephone will function and is assigned an extension number (200~211).
Calls received on the exchange lines will ring at telephone number 200.
Each telephone can make exchange line calls by dialing 0.
Each exchange line is presented at a Function Key with busy lamp indication.

Connecting PCPro to the SL2100

CPU Default IP Address: 192.168.0.10 / 255.255.255.0
VOIP Default IP Address: 172.16.0.10 / 255.255.255.0
(The VOIP IP address is for either built-in VOP or the VOIPDB card)
You can check the IP address at any SL2100 system phone:
Press the centre Navigation Key and dial 841
Direct to Ethernet connector on the SL2100 CPU card.
Via the customer's LAN.
Quick Install Guide – SL2100 with Analogue Trunks rev 1.1
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents