What Is The Sl2100; Outside Lines (Analogue Trunks) Included In This Guide - NEC SL2100 Quick Install Manual

NEC SL2100 Communication System

What is the SL2100?

The SL2100 system consists of a chassis unit with a dedicated slot for the CPU
card and four universal slots for interface cards. Each universal slot supports an
extension interface card, optionally each extension interface card can have a trunk
interface daughter card mounted.
The chassis unit is ventilation cooled (no fan) and can be wall mounted or rack
mounted with the optional rack mount shelf.
Up to three chassis units can be connected together to provide a total of twelve
universal slots.
Interface cards are available for Analogue and ISDN trunks, proprietary SL2100
terminals and analogue telephones.
SIP Trunks and IP terminals are supported without the need for additional system
hardware as eight VoIP resources are built in to the CPU card. VoIP resources can
be expanded to 16 by adding the optional VOIPDB card and further to 128 with
licenses.
InMail voicemail is also available either using the built in storage of the CPU-C1-A or by adding the optional SD
card.
The built in InMail with the CPU-C1-A card provides 4channels and 2hours of storage, this can be expanded to
15hour or 120hour by adding the SD card to the CPU.
The CPU-C1 requires the SD card installed to provide InMail voicemail.
Both CPU's have built in VRS with 4channnels and 100 messages with 2hours message storage.
All equipment will operate in the default/factory setting when the SL2100 is installed.
With the default settings:

Each telephone will function and is assigned an extension number.

Calls received on the Analogue trunk lines will ring at telephone number 200.

Each telephone can make outside calls by dialing 9.

Each trunk line is presented at a Function Key with busy lamp indication.
The system can be easily modified using SL2100 PCPro which has Quick Installation wizards for the majority of
system settings.

Outside lines (Analogue Trunks) included in this guide

The SL2100 has two cards that provide analogue trunks:

IP7WW-308U-A1 – Provides 3 analogue trunks and 8 Hybrid extension interfaces and is installed into one of
the universal slots

IP7WW-3COIDB-C1 – Provides 3 analogue trunks and is a daughter card that is mounted onto one of
extension interface cards (IP7WW-082U-B1 or IP7WW-008U-C1) or the trunk carrier card (IP7WW-000U-
C1)
You can install up to four trunk interface cards within the SL2100 main unit.

The trunk interface card has three connections providing 3 trunks

The trunks connected must be loop start type

Line are connected via a single RJ45 8/8 way socket
Quick Install Guide – SL2100 with Analogue Trunks rev 1.1
4