Securing The Patient With The Pedi-Mate® Infant Restraint System; Installing The Child Restraint With X-Restraint Package - Stryker Power-PRO XT Operation Manual

Adding a restraint strap extension (Continued)
Securing the patient with the Pedi-Mate® infant restraint system
WARNING
Always locate the buckle away from obstructions or accessories on the cot to avoid the risk of accidental release of Pedi-
Mate® infant restraint system and injury to the infant.
To secure the patient with the Pedi-Mate® infant restraint system:
1. Remove any restraints from the cot.
2. Raise the cot backrest to the full upright position.
3. Position the Pedi-Mate® pad flat on the cot backrest with the black backrest straps facing out.
4. Wrap the straps around the cot backrest and insert the ends of the straps through the brackets.
5. Fasten the buckle.
6. Pull on the end of the adjustable backrest strap to tighten.
7. Insert the mainframe straps between the product frame and the mattress.
8. Insert the buckle behind the litter cross brace and bring it up in front of the litter cross brace.
9. Fasten the buckle around the litter cross brace. Leave slack in the strap for final adjustment.
10. Tighten all straps.
Note: For more information about the Pedi-Mate® infant restraint system, see the manufacturer's instructions for use,
operation, and care. Safe and proper use of the Pedi-Mate® infant restraint system is at the discretion of the user. Set
methods and procedures to educate and train your staff on the safe operation or maintenance of this product. These are
general instructions only. Keep these instructions for future reference. These instructions are a permanent part of the
product and should remain with the product even if the product is sold.
Pedi-Mate® is a registered trademark of Ferno Washington, Inc.

Installing the child restraint with X-restraint package

To attach the Britax Meridian SICT (series no. 7200/A/2010), Platinum Pro SICT (series no. 7200/A/2013i), and Millenia
SICT (series no. 7200/A/2013/i) Convertible Child Restraint to the cot with the X-restraint package (6500-001-430):
1. Lay the cot flat.
2. Open the waist restraint straps (6500-001-402 and 6500-001-403). Lay the straps to the side and out of the way.
3. Position the child restraint to face the foot end of the cot.
4. Place the child restraint into the reclined position.
5. Raise the cot fowler up to align with the back of the child restraint.
6. Loop the upper anchorage strap with the anchor fitting and attachment clip from the child restraint around the cot
fowler (Figure 30 on page
48
Operation
Figure 29: Restraint strap extension
49). Pull the adjustment strap to tighten and remove slack.
6506-209-001 REV F www.stryker.com