Pinch Points - Stryker Power-PRO XT Operation Manual

CAUTION (CONTINUED)
• Always grasp and pull the plug, not the cord, when you disconnect the SMRT charger to avoid the risk of damage to
the electrical plug and cord.
• Do not steam clean or ultrasonically clean the product.
• Do not exceed 180 °F (82 °C) as the maximum water temperature.
• Do not exceed 1500 psi (130.5 bar) as the maximum water pressure. If you are using a hand held wand to wash the
product, keep the pressure nozzle at a minimum of 24 in. (61 cm) from the product.
• Always allow to air dry.
• Always remove the battery before you wash the cot.
• Do not clean, service, or perform maintenance while the product is in use.
• Do not steam clean or ultrasonically clean the SMRT Pak.
• Always use authorized parts to avoid the risk of product damage.
• Always check hoses and lines regularly to avoid damage to the cot. Check and tighten loose connections. Hydraulic
lines, hoses, and connections can fail or loosen due to physical damage, kinks, age, and environment exposure.
• Do not tip the cot onto its load wheels and actuate the product as this will allow air to enter the hydraulic system.
• The use of accessories, transducers, and cables, other than those specified or provided by the manufacturer, could
result in increased electromagnetic emissions or decreased electromagnetic immunity and result in improper
operation.
• The emissions characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR 11
class A). If it is used in a residential environment, for which CISPR 11 class B is normally required, this equipment
might not offer adequate protection to radio frequency communication services. The user might need to take
mitigation measures, such as relocating or reorienting the equipment.
• Avoid stacking or placing other equipment adjacent to Power-PRO and SMRT charger to prevent improper operation
of the products. If such use is necessary, carefully observe Power-PRO and SMRT charger and the other equipment
to make sure that they are operating properly.

Pinch points

WARNING
Always keep your hands clear of the red safety bar pivots when you load, unload, or change the height position of the cot.
8
Summary of safety precautions
6506-209-001 REV F www.stryker.com