NetComm 3G27WV-R User Manual page 62

Cal ll Forwarding Busy
Call forwarding busy will divert all incoming c
To e enable Call Forwardin
(Whe ere directory number
Hang g up after you hear 2

To d disable Call Forwardin

Hang g up after you hear 2

To c check the status of Ca

Call Forwar
o
Call Forwar
o
Cal ll Forwarding Not Reachab
Call forwarding busy will divert all incoming c
To e enable Call Forwardin

(Whe ere directory number
Hang g up after you hear 2

To d disable Call Forwardin

To c check the status of Ca

Call Forwar
o
Call Forwar
o
Co nference Call
This can be achieved by performing a hook-f
Wait t for the third party to answer your call and
Please note e: In order to activate
Tro oubleshooting g
Wha at do I do if I have no dial tone?
Plea se follow the proced ure listed below:
1. Check to ma ake sure the phone is
2. Check to ma ake sure you are usin
3. Check to ma ake sure the line light
4. Check to ma ake sure the blue MB
5. Check to ma ake sure your MBB SI
6. Check and s see if you get the dial
I hav ve noise interference during telephone ca
To re esolve this issue, try t the following:
Verif fy that the RJ-11 cab

Try t to remove any teleph

Try r rebooting your 3G27W

YML L38
www w.netcommlimited.co om
calls to a phone numb ber that you desire on nly if your telephone
ng Busy, dial *67*<Di irectory Number>#
r is the number you w wish to forward calls t to)
2 low pitch beeps.
ng Busy, dial #67#
2 high pitch beeps.
all Forwarding Busy, dial *#67# or view th he advanced status p
rding Busy is disable ed if you hear 2 high p pitch beeps.
rding Busy is enabled d if you hear 2 low pi itch beeps.
ble
calls to a phone numb ber that you desire on nly if your telephone
ng Not Reachable dia al *62*<Directory Num mber>#
r is the number you w wish to forward calls t to)
2 low pitch beeps.
ng Not Reachable, d ial #62#, Hang up aft fter you hear 2 high p
all Forwarding Not Re eachable, dial *#62#
rding No Answer is d isabled if you hear 2 2 high pitch beeps.
rding No Answer is e nabled if you hear 2
lash and then by dia lling the third party.
d then perform anoth her hook-flash to conf ference all the parties
a conference call, yo ou will need to have o originated both calls
s plugged into your 3G G27WV-R on either L Line 1 port or Line 2 p
g the correct cable ( Cat-3 UTP Telephone e Cable with RJ-11 p
on the front panel of f the 3G27WV-R turns s solid blue if you lift
B indication light on t the front of the 3G27W WV-R is blinking.
IM card is activated a and insert into your 3 3G27WV-R properly.
tone after rebooting your 3G27WV-R.
alls. How can I fix this s?
le is securely connec cted and not damage ed.
hone splitters from the e connection betwee en your phone and the
WV-R.
is busy on another c all.
page of the managem ment console.
is unreachable by th e network.
pitch beeps.
or view the advance ed status page of the management conso
low pitch beeps.
s together.
.
port.
plugs).
the handset.
e 3G27WV-R.
3G27W WV-R
ole.
3G27WV-R Use er Guide
62