Advertisement
7. Precautions
Cautions for the emulator:
For debugging, be sure to use this product in a combination with the emulator M32100T2-SDI-E, M32170T-SDI or
M32100T-SDI-E.
When starting up the PD32R, select an MCU file according to an MCU and operation mode. For selecting an MCU
file, refer to the release notes of the debugger.
Connect both the SDI MCU control interface cable (10-conductor) and SDI trace interface cable (20-conductor) to
the emulator.
For the precautions for a combination with an emulator, refer to the user's manual of each emulator.
Cautions for Differences Between the Emulator and an actual MCU:
The M32170F6VWG (768 KB of internal flash ROM and 40 KB of internal RAM) on the M32171T-PTC is used
for debugging. Take care of differences of internal memory sizes.
When setting the clock selection switch to "EXT", connect the clock generated by an oscillator of the target system
to pin XIN. The automatic oscillation between XIN and XOUT does not occur.
Load capacity of all the signal lines of the MCU becomes greater than that of the actual signal lines on the MCU.
Therefore, for a part where timing is critical, Give due consideration to its connection
Cautions to Be Taken for This Product:
When attaching the YQPACK144SD, be sure to use the included YQ-GUIDE's.
Notes on This Product:
We cannot accept any request for repair.
To purchase NQPACK144SD and HQPACK144SD, contact the following.
Tokyo Eletech Corporation http://www.tetc.co.jp/
For inquiries about this product or the contents of this manual, contact your local distributor.
Renesas Tools Homepage http://www.renesas.com/en/tools
CAUTION
IMPORTANT
(4/4)
Advertisement
