Replacing Or Installing Components; Replacing A Management Daughter Card For A Cisco Ucs 6248; Removing A Management Daughter Card - Cisco UCS 6248 UP Installation Manual

Installing the Cisco UCS 6200 Series Fabric Interconnect
Note
Step 10
Try removing and reinstalling a component that is not operating correctly. If it still does not operate correctly,
contact your customer service representative for a replacement.
Note
Step 11
Verify that the system software has booted and that the system has initialized without error messages.
If any problems occur, see
issue, contact your customer service representative.
Step 12
Complete the worksheets provided in
Step 13 Configure the primary fabric interconnect as described inthe Configuration Guide for the version of Cisco
UCS Manager that you are using. The configuration guides are available at the following URL:
http://www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_guides_list.html
Step 14 Power up, connect the terminal to the console port, and configure the secondary fabric interconnect as described
in the Cisco UCS Manager Configuration Guide.

Replacing or Installing Components

Caution To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by the
carrier edges only.

Replacing a Management Daughter Card for a Cisco UCS 6248

This procedure will be necessary if you need to return a Cisco UCS 6248 and receive a replacement bare
chassis, which will not have the management daughter card (UCS-FI-DL2), fans, power supplies, or expansion
modules.
Note
If you need to install or replace a Cisco UCS 6296 fabric interconnect, you do not need to remove and install
the management daughter card. The Cisco UCS 6296 has a nonremovable management daughter card.

Removing a Management Daughter Card

Procedure
Step 1 Prepare an antistatic surface for placing removed components.
OL-24475-03
The link LEDs for the Fibre Channel ports remain yellow until the ports are enabled, and the LED
for the Ethernet connector port remains off until the port is connected.
If you purchased this product through a Cisco reseller, contact the reseller directly for technical
support. If you purchased this product directly from Cisco, contact Cisco Technical Support at this
URL: http://www.cisco.com/en/US/support/tsd_cisco_worldwide_contacts.html.
Troubleshooting Hardware Components, on page
Site Planning and Maintenance Records, on page 81
Cisco UCS 6200 Series Fabric Interconnect Hardware Installation Guide

Replacing or Installing Components

87. If you cannot resolve an
for future reference.
39