Cisco UCS 6248 UP Installation Manual page 36

Installing the Cisco UCS 6248 UP Chassis in a Cabinet or Rack
Procedure
Step 1
Install the front rack-mount brackets as follows:
a) Position a front rack-mount bracket against the chassis and align the screw holes as shown. Then attach
the front rack-mount bracket to the chassis with four M4 screws.
b) Repeat with the other front rack-mount bracket on the other side of the chassis.
Figure 17: Attaching Front Rack-Mount Bracket to the Cisco UCS 6248 UP
1
2
Step 2
Install the rack-mount guides on the chassis as follows:
a) Position one of the rack-mount brackets against the side of the chassis and align the screw holes.
b) Attach the bracket to the chassis with two of the flat-head M4 screws.
c) Repeat with the other rack-mount bracket on the other side of the chassis.
Step 3
Attach the slider rails to the rack. Use 2 12-24 screws or 2 10-32 screws, depending on the rack rail thread
type. For racks with square holes, insert the 12-24 cage nuts in position behind the mounting holes in the
slider rails.
a) Repeat with the other slider rail on the other side of the rack.
b) Use the tape measure and level to verify that the rails are horizontal and at the same height.
Cisco UCS 6200 Series Fabric Interconnect Hardware Installation Guide
26
1
Front rack-mount bracket 3
Phillips countersink 4
screws
Installing the Cisco UCS 6200 Series Fabric Interconnect
3
2
Rack-mount guides
Phillips countersink
screws
4
OL-24475-03