Table of Contents
Advertisement
6. A level-shift circuit with AVcc0 and AVcc1 is mounted on the user system interface cable, as
shown in figure 12. At shipment, the jumper pin is inserted in the side of pins 1 and 2 of the P4
short connector. For details on the differences between the target MCU and the emulator, refer to
the H8SX/1650 E6000H Emulator User's Manual (HS1650EPH60HE). For the ranges of input
voltages of AVcc0 and AVcc1, refer to the H8SX/1520 Group Hardware Manual.
Insert the jumper pin in the P4 short connector so that
the higher voltage between AVcc0 and AVcc1 is selected.
Select either AVcc0 or AVcc1 when their potentials are
the same. Do not use the emulator without jumper pins.
User system interface
AVcc0
1.03 k
2 k
AVss
AVcc1
1.03 k
2 k
AVss
Figure 12 Level-shift Circuit with AVcc0 and AVcc1
16
CAUTION
5 V
+
-
5 V
+
-
Emulator station
UVREF3
1
AVcc of MCU
of the emulator
station
3
P4
UVREF1
Settings of short connector:
Between pins 1 and 2: AVcc0
Between pins 2 and 3: AVcc1
Advertisement
Table of Contents
