Configuring The Other Side Of The Vpn Connection; What To Do Next - Cisco ASA 5505 Getting Started Manual

Configuring the Other Side of the VPN Connection

Configuring the Other Side of the VPN Connection
Note

What to Do Next

ASA 5505 Getting Started Guide
10-14
You have just configured the local adaptive security appliance. Next, you need to
configure the adaptive security appliance at the remote site.
At the remote site, configure the second adaptive security appliance to serve as a
VPN peer. Use the procedure you used to configure the local adaptive security
appliance, starting with "Configuring the Security Appliance at the Local Site"
section on page 10-5 and finishing with "Viewing VPN Attributes and
Completing the Wizard" section on page 10-12.
When configuring Security Appliance 2, use the same values for each of the
options that you selected for Security Appliance 1, with the exception of local
hosts and networks. Mismatches are a common cause of VPN configuration
failures.
If you are deploying the adaptive security appliance only in a site-to-site VPN
environment, then you have completed the initial configuration. In addition, you
may want to consider performing some of the following steps:
To Do This...
Refine configuration and configure
optional and advanced features
Learn about daily operations
Chapter 10 Scenario: Site-to-Site VPN Configuration
See...
Cisco Security Appliance Command
Line Configuration Guide
Cisco Security Appliance Command
Reference
Cisco Security Appliance Logging
Configuration and System Log
Messages
78-18003-02