Configuring The Cisco Anyconnect Vpn Client - Cisco ASA 5505 Getting Started Manual

Implementing the Cisco SSL VPN Scenario
Step 3
Step 4

Configuring the Cisco AnyConnect VPN Client

ASA 5505 Getting Started Guide
8-12
Chapter 8
Click Next.
Step 5 of the SSL VPN Wizard appears. This step does not apply to AnyConnect
VPN client connections, so click Next again.
For remote clients to gain access to your network with a Cisco VPN Client, you
must configure a pool of IP addresses that can be assigned to remote VPN clients
as they are successfully connected. In this scenario, the pool is configured to use
the range of IP addresses 209.165.201.1–209.166.201.20.
You must also specify the location of the AnyConnect software so that the
adaptive security appliance can push it to users.
In Step 6 of the SSL VPN Wizard, perform the following steps:
Scenario: Configuring Connections for a Cisco AnyConnect VPN Client
78-18003-02