Image Settings - D-Link DCS-6116 User Manual

Section 3 - Configuration
This page allows you to tune the white balance, brightness, saturation, contrast, and
sharpness settings for the video.
Color: Select either a Color or B/W (black and white, monochrome) video display.
Power Line Frequency: Select either 50 or 60 Hz depending on your region.
Video Orientation: Flip will vertically rotate the video. Mirror will horizontally rotate
the video. You may select both options if camera is being installed upside down.
White Balance: This adjusts the relative amount of red, green and blue primary
colors in the image so that the neutral colors are reproduced correctly.
• Auto: The camera automatically adjusts the color temperature of the light in
response to different light sources. The white balance setting defaults to Auto
and works well in most situations.
• ATW: ATW continuously adjusts camera color balance in accordance with any
change in color temperature.
• Fixed: Follow the steps below to manually set the white balance to
compensate for the ambient lighting conditions.
1. Set the White balance to Auto and click Save.
2. Place a sheet of white paper in front of the lens, then allow the camera to adjust
the color temperature automatically.
3. Select Fixed to confirm the setting while the white balance is being measured.
4. Click Save to enable the new setting.
Digital Zoom: Select the amount of digital zoom from x2 to x8.
Overlay Title and Time Stamp on Video: Select this option to place the video title
and time on the video streams. (When the frame size is set to 176 x 144 only the
time will be stamped on the video streams.)
Note:
The "Sensor Settings" and "Image Settings" share the same Profile 2 settings.
D-Link DCS-6116 User Manual

Image Settings

33