Set The Remote Control Settings; Set The One/Two-Button Operation; Set The Temperature Scale; Set The Day And Time - Bellfires Smart Bell 65 MF User Manual

•
4.2

Set the remote control settings

4.2.1

Set the one/two-button operation

• When the display shows '1', the one-button operation mode is selected.
• When the display shows '2', the two-button operation mode is selected. This mode will
prevent accidental start-up of the appliance.
1.
2.
3.
4.
4.2.2

Set the temperature scale

• If you set the temperature scale to °C, the display shows a 24-hour clock.
• If you set the temperature scale to °F, the display shows a 12-hour clock.
•
4.2.3

Set the day and time

1.
2.
3.
4.
5.
6.
7.
Smart Bell 65-55
N N ote:
• The main burner burns at maximal height after start-up.
• If the pilot light goes out and you start the appliance too early, the remote
control will start but the fire will not burn. Restart the remote control.
Start the appliance with the on/off button(s). Refer to
Remove the batteries from the remote control.
Put the batteries in the remote control. The screen starts
to blink.
Push and hold the on/off button for approximately 10
seconds. The current setting of the remote starts to blink
When the number changes and stops to blink, release
the button.
• The '1' changes into '2' when the remote control is
set to the two-button operation.
• The '2' changes into '1' when the remote control is
set to the one-button operation.
Push the on/off button and the countdown timer button at the same time to change
the temperature scale between °C and °F.
Push the up and down buttons at the same time. The day flashes in the display.
Use the up and down buttons select the day of the week (1 for Monday, 2 for
Tuesday etc.).
Push the up and down buttons at the same time. The hour flashes in the display.
Use the up and down buttons to select the hour.
Push the up and down buttons at the same time. The minutes flash in the display.
Use the up and down buttons to select the minutes.
Push the up and down buttons at the same time to store the day and time settings.
Operation
4.3
.
AM
PM
ON
OFF
1 2
15