Change The Settings; Set The Temperature For The Thermostatic Mode - Bellfires Smart Bell 65 MF User Manual

Operation
Action
Decrease the fan
speed
Increase the fan
speed
4.4

Change the settings

4.4.1

Set the temperature for the thermostatic mode

1.
2.
3.
20
C C aution:
Ensure that the convection fan does not run constantly and never switches off. If the
main burner is not switched off completely, (the microswitch on the gas regulator block
has not come on yet!) the convection fan will continue to run and will NOT switch off!
This can occur if the main burner is extinguished by the thermostat or is not completely
switched off manually.
Preconditions
The fan symbol is on.
The fan symbol is on.
Note:
Maximum thermostat 60°C.: The receiver in the appliance is fitted with a 60°C
maximum thermostat. When this thermostat is activated, the main burner will
be completely switched off and the pilot light will continue to burn. The
convection fan will then automatically switch to the highest setting and
continue to run for a maximum of 10 minutes. The temperature in the receiver
is measured every minute. The appliance cannot be operated again until the
temperature has returned to below 60°C.
Push and hold the thermostatic mode button until the
thermostatic mode symbol appears and the temperature
flashes.
Use the up and down buttons to set the temperature.
Push the thermostatic mode button to store the
temperature or wait until the temperature stops to flash.
Steps Result
• Push and hold
until the fan
symbol flashes
•
Push until
you have the de-
sired fan speed
• Push and hold
until the fan
symbol flashes
•
Push until
you have the de-
sired fan speed
Smart Bell 65-55