Engineering Notes; Commissioning Notes; Warranty - Siemens RVP201.0 Manual

Engineering notes

Commissioning notes

Disposal

Warranty

Siemens
Building Technologies
The wires of the measuring circuits carry extra low voltage
The wires to the actuator and the pump carry AC 24...230 V
The local electrical regulations must be complied with
Sensor cables must not be run parallel to mains carrying cable for loads such as
actuator, pump, burner, etc. (safety class II to EN 60730)
The maximum limitation of the boiler temperature may not be used as a safety func-
tion. For that purpose a thermostat or safety limiter must be connected at terminals
L–F1/F4
Setpoint adjustments:
Normal temperature (in °C room temperature)
Setback (in °C room temperature)
D.h.w. (only with the RVP211)
Settings to be made by the heating engineer:
Slope of heating curve
Authority of room temperature
ECO heating limit
Maximum limitation of the flow or boiler temperature
Type of regulating unit (mixing valve or burner)
Type of control (three- or two-position)
Frost protection activated or deactivated
Priority of d.h.w. heating (only with the RVP211)
The controller is supplied complete with installation instructions and operating instruc-
tions.
The devices are considered electronics devices for disposal in terms of European Di-
rective 2012/19/EU and may not be disposed of as domestic garbage.
Dispose of the devices through channels provided for this purpose.
Comply with all local and currently applicable laws and regulations.
When using the RVP201/211 together with third-party devices not specifically
mentioned, correct functioning must be ensured by the user. In that case, Sie-
mens will assume no responsibility for service and warranty.
Heating Controller RVP201, RVP211
7/12
CE1N2464en
2017-07-31