Connection Diagrams - Siemens RVP201.0 Manual

Connection diagrams

For low voltage
D1 D2
B9
= Measurement of d.h.w. temperature with sensor (only with the RVP211)
= External switch for changeover of operating mode
= Measurement of d.h.w. temperature with a thermostat plus an intermediate relay (only with the RVP211)
For mains voltage
F1/F4 F2 F3
Q1
3
F1/F4
= Connection of three-position actuator (flow temperature control), heating circuit pump and d.h.w. charging
pump (d.h.w. charging pump only with the RVP211)
= Connection of burner (boiler temperature control)
= Connection of two-position actuator (flow temperature control)
= Connection of actuator for changeover valve (only with the RVP211)
A6 Room unit
B1 Flow or boiler temperature sensor
B3 D.h.w. temperature sensor (only with the RVP211)
B9 Outside sensor
E1 Burner
F1 Thermal reset limit thermostat
F2 Manual reset safety limit thermostat
F3 D.h.w. thermostat (only with the RVP211)
10/12
Siemens
Building Technologies
1
B3
B3
1
Q3/Y3
M3
M1
M3
N1
S1
Y1
Y2
Y3
Heating Controller RVP201, RVP211
2
S1
F1/F4
E1
F1 F2
4
F3
Q3/Y3
Y3
Heating circuit pump
D.h.w. charging pump (only with the RVP211)
Controller RVP201/211
External switch
Three-position actuator
Two-position actuator
Actuator for d.h.w. changeover valve (only with the RVP211)
B3
2
3
T
F3
CE1N2464en
2017-07-31