Harmar Mobility pinnacle SL600 Owner's Manual page 6

Pinnacle Stair Lift
Stair Lift Operation (cont)
Step 4:
If you release the control switch the lift will stop. Continue to press the control until you reach the
landing. The lift will gently stop at the appropriate, preset point.
Step 5: To safely exit the lift, unbuckle the seat belt, support yourself by the armrests, rise and step off the
footrest. At the upper landing, ensure that the seat is fully swiveled and locked before rising. If you do not
intend to use the lift again immediately, the seat and armrests may be folded up to minimize obstruction to
people walking on the stairs.
When transferring in or out of the seat
use the armrests to assist you. Ensure
the seat is securely latched before
WARNING transferring in or out.
Step 6:
To operate the lift remotely, continuously press the appropriate up or down button on the call/
send hand control unit. Like all infrared devices, the signal may be interrupted if the hand control unit is not
in the line of sight of the front of the stair lift. If this happens the lift may temporarily stop but will restart
immediately, as long as the call/send is pressed continuously.
If you are operating the lift remotely on behalf of another person, please ensure that they are securely
seated with the seat belt engaged. Always keep the person in line of sight before commencing movement.
Encountering an Obstruction
An amber light and single beep indicate that the
lift has touched an obstruction. At this point, the
lift may only be operated in the opposite direction
of the obstruction. Clear the obstruction before
proceeding.
6
The folding rail option deploys automatically as the stair lift chassis
descends, there is no need to stop or engage another control.
It also retracts automatically when the stair lift chassis ascends
so the rail will not protrude into a walkway or in front of a door.
When you exit the stairlift at the lower landing, you may either
leave it at the bottom, or, by using your call/send, elevate the stair
lift chassis up into the stairwell just enough to raise the folding
rail to the upright position. In either position, the stair lift will
continue to be charged when not in use.
| www.harmar.com
Tip: When leaving the lift at the bottom of the
landing, you can use the call/send to place the lift
back up in the stairwell up to 3' while maintaining
charging connection.
Remote Control
Folding Rail Operation
© 2018 Harmar Mobility, LLC • All Rights Reserved