Advertisement
User
Safety Messages (review carefully)
The purpose of this section is to provide the User with specific replacement procedures for the
Card Printer. Please review standard precautions (to take) while performing these replacement
procedures.
Symbol
Critical Instructions for Safety purposes
Danger:
Failure to follow these installation guidelines can result in death or serious
injury.
Information that raises potential safety issues is indicated by a warning symbol (as
shown to the left).
To prevent personal injury, refer to the following safety messages before
performing an operation preceded by this symbol.
To prevent personal injury, always remove the power cord prior to performing
repair procedures, unless otherwise specified.
To prevent personal injury, make sure only authorized service personnel perform
these procedures.
Caution:
This device is electrostatically sensitive. It can be damaged if exposed to static
electricity discharges.
Information that raises potential electrostatic safety issues is indicated by a warning
symbol (as shown to the left).
To prevent equipment or media damage, refer to the following safety messages
before performing an operation preceded by this symbol.
To prevent equipment or media damage, observe all established Electrostatic
Discharge (ESD) procedures while handling cables in or near the Circuit Board and
Printhead Assemblies
To prevent equipment or media damage, always wear an appropriate personal
grounding device (e.g., a high quality wrist strap grounded to avoid potential
damage).
To prevent equipment or media damage, always remove the Ribbon and Cards
from the Printer before making any repairs, unless otherwise specified.
To prevent equipment or media damage, take jewelry off of fingers and hands,
as well as thoroughly clean hands to remove oil and debris before working on the
Printer.
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
HDP8500 Printhead Replacement Guide L001638 rev 1.1
4
Advertisement
