Advertisement
User
Step
Procedure
21
Complete the replacement by doing the following steps. See below for details.
a. Replace the complete Printhead Assembly. IMPORTANT NOTE: Locate the
Printhead Resistance value stamped on the printhead BEFORE installing. This
VALUE is needed for step 26
b. Replace the Printhead cable and ground strap.
c. Replace the Printhead Motor Mount (D910052).
Printhead surface does not get scratched by any other Printer parts.
22
Fit the Frame Mount pin into the slot, provided within the Printer Frame.
(Important: Verify the mount pin is solidly fitted into the hole, as shown below.)
Display – Frame Mount Pin
Display – Print Platen Roller Slot and Frame Mount Pin
(continued next page)
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
HDP8500 Printhead Replacement Guide L001638 rev 1.1
Caution: When replacing the Printhead Assembly, ensure that the
13
Advertisement
