Remote Controller Operation - Hitachi RCIM-FSN2 Installation And Operation Manual

„
DSW7: Fuse Recover

6 REMOTE CONTROLLER OPERATION

6.1. SETTING THE FILTER INDICATION INTERVAL
„
Step 1: Changing to Optional Setting Mode
mode is changed to the field setting mode, "SERVICE" is
indicated and " " flickers. When "
: ; switch and set "
„
Step 2: Selection of Indoor Unit for Optional
Setting
o The flickering indication of "
p
q
" is not indicated,
". In this condition,
: ;
"stops.
: ;
„
DSW8: (Not used)
NOTE:
-
The mark "„" indicates position of dips switches. Figures
show setting before shipment or after selection.
NOTE:
-
In case that the both indications of the ADDS. (Address)
and RN. (Refrigerant Cycle Number) show "", the
same setting is performed to all the indoor units.
-
The indoor units not connected are not indicated.
„
Step 3: Optional Setting Items and Changing
Setting Conditions
o
p
: ;
"' ". In case of setting other indoor unit, press the :
item "Step 2 Selection of Indoor Unit for Optional Setting".
FILTER Indication Interval
„
Step 4: Cancelling Optional Setting Mode
NOTE:
The Label for checking the contents of the setting is
attached to the holding bracket. Write down the
contents of the setting on the label.
6
;