Table of Contents
Advertisement
NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
REMOTE CONTROLLER
This controls the operation of the indoor unit. Signal range to reach indoor unit is about 7 meters. If
inverter lamp is used, the range of control may be shorter.
This unit can be fi xed on a wall using the fi xture provided. Before fi xing it, make sure the indoor unit
can be controlled from the remote controller.
Transmission sign
●
The transmission sign blinks when a signal is sent.
Display
●
This indicates the room temperature selected, timer status, function
and intensity of circulation selected.
AIR SLEEP TIMER button
●
Use this button to set the air sleep timer mode.
TEMPERATURE button
●
Use this button to raise or lower the temperature setting. (Keep pressed,
and the value will change more quickly.)
START/STOP button
●
Press this button to start or to stop operation.
FAN SPEED selector button
●
This determines the fan speed. Each time you press this button, the
intensity of circulation will change from
➞
➞
(MED)
AUTO SWING button
●
Controls the angle of the horizontal air defl ector.
REFRESH button
●
Use this button to refresh the room condition.
RESET button
●
ONE TOUCH POWERFUL
●
Use this button to deliver faster and more comfortable air-conditioning
or start
operation.T
FROST WASH button
●
During OFF mode, press this button to set the Frost Wash operation.
OFF-TIMER button
●
Select to turn OFF time.
ON-TIMER button
●
Select to turn ON time.
MODE selector button
●
Use this button to select MODE. Each time you press this button the
MODE selection will change from
➞
(DEHUMIDIFY)
However, during OFF mode SILENT will be skipped.
Precautions for Use
Do not put the remote controller in the following places.
●
In direct sunlight.
●
In the vicinity of a heater.
●
Handle the remote controller carefully. Do not drop it on the
●
fl oor, and protect it from water.
Once the outdoor unit stops, it will not restart for about 3
●
minutes (unless you turn the power switch off and on or unplug
the power cord and plug it in again).
This is to protect the device and does not indicate a failure.
– 6 –
➞
(LOW)
(SILENT).
buttonA
(COOLING)
➞
(FAN).
➞
(AUTO)
(HI)
➞
(SILENT)
Advertisement
Table of Contents
