Transmitter And Receiver Binding; Understanding The Primary Flight Controls - Blade Stealth Conspiracy 220 Instruction Manual

EN

Transmitter and Receiver Binding

To bind or re-bind your quadcopter to your chosen transmitter, follow the directions below.
Binding Procedure
1. Select the correct model in your transmitter.
2. Power off your transmitter.
3. Lower the throttle fully.
4. Power the quadcopter on while pressing the bind button located on the left side of the fl ight con-
trol board, as shown in the illustration. Do not press the button on the right side of the fl ight board.
5. Follow the procedures of your specifi c transmitter to enter Bind Mode.
6. The receiver LED glows solid orange indicating binding was successful.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions. If needed, contact
the appropriate Horizon Product Support offi ce. For a list of compatible DSM
Failsafe
The included receiver does not have failsafe capabilities. Failsafe is detected at the fl ight controller. In the event of a loss of signal
to the receiver the fl ight controller will cut power to the motors to prevent a fl y-away situation.

Understanding the Primary Flight Controls

If you are not familiar with the controls of your quadcopter, take a few minutes to familiarize yourself with them before
attempting your fi rst fl ight.
Throttle
Throttle up
Rudder
Rudder left
Elevator
Elevator down
Aileron
Aileron left
Left Side View
Climb
Nose Yaws Left
Left Side View
Forward
Rear View
Left
®
transmitters, please visit www.bindnfl y.com.
Throttle down
Rudder right
Elevator up
Aileron right
6
Left Side View
Descend
Nose Yaws Right
Left Side View
Backward
Rear View
Right