Table of Contents
Advertisement
Transmitter and Receiver Binding
To bind or re-bind your quadcopter to your chosen transmitter, follow the directions below.
Binding Procedure
1. Select the correct model in your transmitter.
2. Power off your transmitter.
3. Lower the throttle fully.
4. With the transmitter off, power on the quadcopter. The receiver will attempt to connect to the last transmitter it was
bound to. The receiver LED will rapidly fl ash orange indicating the receiver has entered Bind Mode.
5. Follow the procedures of your specifi c transmitter to enter Bind Mode.
6. The receiver LED glows solid orange indicating binding was successful.
IMPORTANT: After the receiver has been bound to your transmitter, always power your transmitter on fi rst so the
receiver will not enter bind mode. If the model enters bind mode unintentionally, power off the model, ensure the trans-
mitter is powered on with the correct model selected and then power the model on again. The receiver will not lose its
previous bind information if it enters bind mode and does not bind.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions.
If needed, contact the appropriate Horizon Product Support offi ce. For a list of compatible DSM
please visit www.bindnfl y.com.
Failsafe
The included receiver does not have failsafe capabilities. Failsafe is detected at the fl ight controller. In the event of a loss of
signal to the receiver the fl ight controller will cut power to the motors to prevent a fl y-away situation.
Understanding the Primary Flight Controls
If you are not familiar with the controls of your quadcopter, take a few minutes to familiarize yourself with them before
attempting your fi rst fl ight.
Throttle
Throttle up
Rudder
Rudder left
Left Side View
Climb
Nose Yaws Left
Throttle down
Rudder right
7
®
transmitters,
Left Side View
Descend
Nose Yaws Right
EN
Advertisement
Table of Contents
