Front Panel Programming Mode Flow Chart - Kenwood NX-5800 Service Manual

• Front panel programming mode flow chart

Enter the Front panel programming mode
by using section "2.2.2 How to Enter Each Mode".
[ ] or [ ]
Keep This Change?
[ ]
Channel Name
[ ]
[ ] or [
Transmit Power Low
[ ]
[TX Frequency]: "OFF"
[Channel Type]: "Analog"
[ ]
[Channel Type]: "Analog"
[ ]
[TX Frequency]: "OFF"
[Channel Type]: "NXDN"
[ ]
[Channel Type]: "NXDN"
[ ]
[TX Frequency]: "OFF"
[Channel Type]: "P25"
[ ]
Talkgroup List ID Amount: 0
[ ]
1-10 (No.RA017<Rev.002>)
Front panel Programming mode
] [ ] or [ ]
Medium High
Zone-Channel Format
"System Type = Conventional"
[Channel Type]:
"P25"
[Channel Type]: "NXDN"
Talkgroup ID List Number
Note:
Zone-Channel Format allows you to whether to configure for
each zone the channels in the same system, or channels in different system.
P25 can be configured for System Select or Channel Type if one or
more P25 conventional system is preconfigured by the FPU.
Input Password
Clone/Front Panel Password
[ ]
[ ]
Zone Select
[ ]
Channel Select
[ ]
Blank Channel
[ ]
[No]
is "Personality".
[No]
there is more than two.
System Select Analog
[ ]
RX Frfequency
[ ]
TX Frequency
[ ]
[ ]
Channel Type
[ ]
Channel Spacing 12.5kHz
[ ]
[Channel Type]: "Analog"
RX Signaling
[ ]
[TX Frequency]: Other than "OFF"
[Channel Type]: "Analog"
TX Signaling
RX RAN
[ ]
[TX Frequency]: Other than "OFF"
[Channel Type]: "NXDN"
TX RAN
RX NAC
[ ]
[TX Frequency]: Other than "OFF"
[Channel Type]: "P25"
TX NAC
[ ]
[Channel Type]: "P25"
Talkgroup ID List Amount must not be 0.
Select the setting channel.
[ ] or [ ] [ ] or [ ]
P25 NXDN
OFF
[System Type]: "P25"
[ ] or [ ]
P25
Analog
[System Type]: "NXDN"
NXDN
[ ] or [ ]
[System Type]: "Analog"
[ ] or [ ]
25.0kHz
When the KPG-D1N is used,
25.0kHz may not be allowed depends on the frequency.
[System Type]: "NXDN"
[ ] or [ ]
6.25Hz
[ ] or [ ] [ ] or [ ]
OFF QT DQT N
[ ] or [ ] [ ] or [ ]
OFF QT DQT N
[ ] or [ ]
DQT I
[ ] or [ ]
DQT I