Power Connector Cable (Dc-In) - HP 15 Maintenance And Service Manual

Power connector cable (DC-in)

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the optical drive (see
5. Remove the bottom cover (see
6. Remove the battery (see
7. Remove the system board (see
8. Remove the display (see
Remove the power connector cable:
1. Remove the cable from the clips built into the computer (1).
2. Remove the power connector cable from the computer (2).
Reverse this procedure to install the power connector cable.
74 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Optical drive on page
Bottom cover on page
Battery on page 40).
System board on page
Display assembly on page
33).
37).
70).
61).
Spare part number
L20475-001