Configuration Examples For Implementing Amt - Cisco CRS Series Configuration Manual

Configuration Examples for Implementing AMT

DETAILED STEPS
Command or Action
Step 1
configure
Step 2 router amt
Example:
RP/0/RP0/CPU0:router(config) # router amt
Step 3
relay ipv4
Example:
RP/0/RP0/CPU0:router(config-amt-relay-v4) # relay ipv4
Step 4 Use one of these commands:
• advertisement-address relay-address
• gateway gateway-address
• gateway-filter acl-name
• maximum-gateway value
• maximum route value
• mtu mtu-value
• ttl ttl-value
• tos tos-value
• qqic qqic-value
Example:
RP/0/RP0/CPU0:router(config-amt-relay-v4) # maximum
gateway 100
Step 5
exit
Example:
RP/0/RP0/CPU0:router(config-amt-relay-v4) # exit
Step 6 commit
Configuration Examples for Implementing AMT
This sections provides configuration examples:
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
198
Implementing Automatic Multicast Routing:
Purpose
Enters the AMT configuration mode.
Enters the AMT relay IPv4 tunnel submode.
Configures the limit for the selected AMT
parameter.
This step can be repeated to configure
Note
all the required parameters.
Exits from the current mode.