Cisco CRS Series Configuration Manual page 132

Interconnecting PIM-SM Domains with MSDP
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. ipv4 address address mask
4. exit
5. router msdp
6. default-peer ip-address [prefix-list list]
7. originator-id type interface-path-id
8. peer peer-address
9. connect-source type interface-path-id
10. mesh-group name
11. remote-as as-number
12. commit
13. show msdp [ipv4] globals
14. show msdp [ipv4] peer [peer-address]
15. show msdp [ipv4] rpf rpf-address
DETAILED STEPS
Command or Action
Step 1
configure
Step 2 interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface
loopback 0
Step 3 ipv4 address address mask
Example:
RP/0/RP0/CPU0:router(config-if)# ipv4 address
10.0.1.3 255.255.255.0
Step 4
exit
Example:
RP/0/RP0/CPU0:router(config-if)# end
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
122
Implementing Multicast Routing on Cisco IOS XR Software
Purpose
(Optional) Enters interface configuration mode to define the
IPv4 address for the interface.
This step is required if you specify an interface type
Note
and number whose primary address becomes the
source IP address for the TCP connection.
(Optional) Defines the IPv4 address for the interface.
This step is required only if you specify an interface
Note
type and number whose primary address becomes the
source IP address for the TCP connection. See optional
for information about configuring the connect-source
command.
Exits interface configuration mode.