Implementing Automatic Multicast Routing:
DETAILED STEPS
Step 1
Step 2
Step 3
Configuring AMT
This procedure describes the steps involved in configuring various AMT parameters.
The AMT commands used in this configuration procedure, are discussed in detail in the Cisco IOS XR
Multicast Command Reference for the Cisco CRS Router.
.
SUMMARY STEPS
1. configure
2. router amt
3. relay ipv4
4. Use one of these commands:
5. exit
6. commit
Command or Action
configure
router amt
Example:
RP/0/RP0/CPU0:router(config) # router amt
commit
• advertisement-address relay-address
• gateway gateway-address
• gateway-filter acl-name
• maximum-gateway value
• maximum route value
• mtu mtu-value
• ttl ttl-value
• tos tos-value
• qqic qqic-value
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
Configuring AMT
Purpose
Enters the AMT configuration mode.
197